Loading ...
Loading ...
Loading ...
Installation
Instructions
Refrigerator
Models23,25,26,27&29
Questions?Carl 800.GE.CARES(800.4321737)or Y.it ourWeh_iteat:GEAppliances.comIn Canada, carl 1.800.361.3400or visit ourWebsiteat:geappliances.ca
I
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - Savethese
instructions for local inspector's use,
• IMPORTANT - all
governing codes and ordinmaees,
• Note to Ii_taller - Be sure to leave these
instructions ,_th the Consnmer.
• Note to Consumer - Keep these instructions
Inr future rt4"erence.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Completion time - Refrigerator Installation
15 minutes
• Proper installation is die responsibility of the
installer.
• Product failure due to improper installation is not
covered under the _Narranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icernaker, it ,'/ill have to be
connected to a cold water line. AGE water supply kit
(containing tubing, shutoff _alve, fittings and
instructions) is a_ilable at extra cost from your dealer,
by visiting our Welxsite at GEAppliances.oom (ill
Canada at geapplianees.ca) or from Parts and
Accessories, 800.626.2009 (in Canada 1.888.261.3055).
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to nlaintam proper temperatures.
• Do not install the refrigerator where the ttmaperature
will go above 100°F (37_C) because it will not perform
properly.
• Install it on a flc×_r strong ennugh to support it fully
loaded.
CLEARANCES
Alk_ the fi)llowing deamnces for ease of inshalhdon,
proper air circulation and phmthing and electrical
connections:
23" 25" 26', '27"and 29"
Sides 1/8" (4 ram) 1/8" (4 ram)
• Top l" (25 ram) 1" (25 mm)
• Back 1/2" (13 ram) 1" (25 ram)
ROLLERS
The rollers have 3 purpose_
• Rx)llersadjust so the door doses easily when opened
about halfway. [Raksethe frontalxmt 5/8" (16 man) from
the floor]
• Rollers ad.jostso the refrigerator ts firmlypositioned on
the floor and does matwobble.
• Rollers allow_m to move the refrigerator awayfrom the
wall for deaning.
Final hweling adjttstmcnts sholdd be made after the
refrigerator has been installed.
To adjust the rollers _a 25', 26', 27' and 29' models:
• Turn the roller
dockwise to raiseadjmllng _re'^_ "Jl_-
the refrigerator,
eotmterdodtwise to
lower it. Use a ,3/8"
hex socket or wrench,
or an adjttslable \
wrench. Rolleradjustingscrew
24
Loading ...
Loading ...
Loading ...