Loading ...
Loading ...
Loading ...
5.2.1 Connecting to the water supply
PREVENTING THE RISK OF CLOGGING OR DAMAGE: IF THE
WATER PIPE IS NEW OR HAS NOT BEEN USED FOR A LONG
TIME, BEFORE CONNECTING TO THE WATER SUPPLY CHECK
THAT THE WATER IS CLEAR AND FREE OF IMPURITIES, TO
PREVENT DAMAGE TO THE APPLIANCE. THE DISHWASHER
MUST ALWAYS BE CONNECTED TO THE WATER SYSTEM WITH
NEW HOSES; OLD OR USED HOSES MUST NEVER BE REUSED.
5.2.1.1 Connecting to the water tap
Connect the inlet hose to a threaded ¾” gas cold water tap, fitting the
supplied filter (ref. A fig.9). Firmly secure the hose by tightening the
relative ring nut with your hands (ref. B fig. 9); fi nish by tightening
another ¼ turn using a pair of plumbing pliers. For models fi tted with
ACQUASTOP (ref. C fig. 9) the fi lter is already present in the threaded
ring nut.
The dishwasher can be fi lled with water at a temperature of less than
60°C (140°F).
If the appliance is fi lled with hot water, washing times will be reduced by
about 20 minutes, but effi ciency will be slightly impaired. Make the
connection to the domestic hot water tap using the same methods
described for connecting the appliance to the cold water tap.
Recommended temperature: 49°C (120°F), max. 60°C (140°F).
Recommended water pressure: 0.5 - 9 bar (7 -130 PSI).
If the pressure is too high, fi t a pressure reducer.
A rubber hose connected to a sink spray may burst if installed on the
same pipes feeding the dishwasher. If your sink is fi tted with this
accessory, remove the hose and plug the hole.
INSTALLATION INSTRUCTION
EN
14
Fig. 9
Loading ...
Loading ...
Loading ...