Loading ...
Loading ...
Loading ...
4
Installation
Excessive Weight Hazard !
Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
General Instructions:
1. Remove packaging materials.
2. CAUTION:
After unpacking you MUST allow this freezer to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the
compressor and stabilize. Failure to do so may adversely affect
performance and the lifetime of this unit.
3. Remove tape and glue residue from surfaces before turning on the
appliance. Rub a small amount of liquid dish soap over the adhesive with
your fingers. Rinse with warm water and dry.
4. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage
the surface of your appliance.
5. When Moving Your Appliance:
Your appliance is heavy. When moving the appliance for cleaning or
service, be sure to protect the floor. Always pull the appliance straight out
when moving it. Do not wiggle or “walk” the appliance when trying to
move it, because floor damage can occur.
6. Clean Before Using:
After you remove all of the packaging materials, clean the inside of your
appliance before using it. See cleaning instructions in Appliance Care.
7. Some models have leveling legs. Level as necessary for best
operation.
8. If your appliance has casters, after moving into place, lock the brakes on
those casters supplied with brakes. Always unlock before moving the
appliance for cleaning.
Location and Clearances:
IMPORTANT: Do not install the appliance near an oven, radiator, or other
heat source, nor in a location where the temperature will fall below 41°F
(5°C). Do not place in direct sunlight.
Check the strength of the floor before installing your appliance. It should hold
Loading ...
Loading ...
Loading ...