Loading ...
Loading ...
Loading ...
12
Installation
3. Install the assembled mounting
frame and the lower duct divider into
the rooftop opening. Make sure the
“THIS WAY FRONT” mark is facing
front (the direction of the vehicle)
while installing. (Fig. 4)
Fig. 4
4. Fix the assembled mounting frame
and lower duct divider into the rooftop
unit using 4 bolts provided. (Fig. 5-a)
Pull to remove the film off the double
sided sticky tape on the inner side of
the lower duct divider. (Fig. 5-b)
NOTE: If bolts are left loose there
may not be an adequate roof seal or
if over tightened, damage may occur
to the rooftop base or mounting
frame. Evenly tighten the four bolts
to a torque of 40 to 50 inch pounds.
This will compress the roof gasket to
approximately ⁄”.
a
b
Fig. 5
5. Stick the upper duct divider into the
assembled mounting frame.
NOTE: Make sure the upper duct
divider is pressing against the ceiling
before finally sticking it. (Fig. 6)
Upper Duct
Divider
Fig. 6
6. Peel to remove the release paper
from the EVA foam, overlap the sticky
side over all gaps and compress to
seal and insulate the entire section.
(Fig. 7)
PE Foam
Fig. 7
7. Remove the cable compartment cover
using a Phillips screw driver. (Fig. 8)
Fig. 8
Loading ...
Loading ...
Loading ...