Loading ...
Loading ...
Loading ...
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does not occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could ignite with risk of injury.
Match Lighting
ADo not Iean over grill while lighting.
1. Open lid during iighfing.
2. Place match into match holder (hanging on right back leg).
Light match, piace into iighfing hote on left side of firebox.
3. Turn right knob to HI position. Be sure burner iighfs and stay tit.
4. Light other burners fotiow with step 3.
Sideburner Match Lighting
1. Open sideburner lid. Turn on gas at LPcylinder.
2 Place lit match near burner
3 Turn sideburner knob to HI Be sure burner lights and stays tit
Burner Flame Check
• Remove cooking grates and heat diffusers Light burners, turn
knobs from HI to LO You should see a smaller flame in
LO position than seen on HI Perform burner flame check
on sideburner, also Always check flame prior to each use If
only tow flame is seen refer to "Sudden flame drop or low flame" in
the Troubleshooting Section
Turning Grill Off
• Turn all knobs to OFF position Turn LPcylinder off by turning
Igniter Check
• Turn gas off at LPcylinder Press and hold electronic igniter
button "Click" should be heard and spark seen each time
between collector box or burner and electrode See
"Troubleshooting" if no click or spark
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves Knobs lock in OFF position To check
valves, first push in knobs and release, knobs should spring
back If knobs do not spring back, replace valve assembly
before using grill Turn knobs to LOW position then turn back to
OFF position Valves should turn smoothly
Hose Check
• Before each use, check to see if hoses are cut or worn
Replace damaged hoses before using grill Use only
valve/hose/regulator as specified in the parts list of this Use & Care
Guide
General Grill Cleaning
• Do not mistake brown or black accumulation of grease and
smoke for paint Interiors of gas grills are not painted at the
factory (and should never be painted) Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom Rinse and allow to completely
air dry Do not apply a caustic grill/oven cleaner to painted
surfaces.
• Porcelain surfaces: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
• Painted surfaces: Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
n.onabrasive cloth.
• Stainless steel surfaces: To maintain your grill's high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad. Use only in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
• Cooking surfaces: If a bristle brush is used to clean any of
the grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling. It is not recommended to
clean cooking surfaces while grill is hot.
8 ° 16198-40700219
Loading ...
Loading ...
Loading ...