Loading ...
Loading ...
Loading ...
37
BEFORE YOU CALL
Soil not completely removed after
self clean.
Self clean was interrupted. Review instructions on
“Self Clean” on page 26.
Excessive spills on oven bottom. Remove excessive spills before starting self clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket,
and the small area at the front center of the oven bottom. These areas are not in the
self-cleaning area, but get hot enough to burn on residue. Clean these areas before
starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon
brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
The oven control display shows
"SCC” and self-clean is not
working.
If the cooktop is used during a self-clean cycle, the oven may turn off. The oven
control display will show “SCC" for 5 seconds. The oven door will remain locked until
the oven has cooled down below cleaning temperature. If the oven is below cleaning
temperature, the user can start another clean cycle immediately. If the oven is in
cleaning temperature range, another self-clean cycle can be set once the door
unlocks (up to 4 hours).
Other Problems
Appliance is not level. Be sure the floor is level, strong, and stable enough to adequately support the range.
If the floor is sagging or sloping, contact a carpenter to correct the situation.
Poor installation. Place the oven rack in the center of the oven. Place a level on the
oven rack. Adjust the leveling legs at the base of the appliance until the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure cabinets are
square and have sufficient room for appliance clearance.
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tightly. Contact the builder or installer to make
the appliance accessible.
Carpet interferes with appliance. Provide sufficient space so the appliance can be
lifted over carpet. Installation over carpet is not advised. See the installation instruc-
tions for guidelines specific to your appliance.
Oven light does not work. Be sure the oven light is secure in the socket. See
“Replacing the oven interior light
bulb” on page 32.
Problem Cause / Solution
Loading ...