Loading ...
SafetyFirst..................................FrontCover
IfDoor Must Be Removed ........................,...2
InstallIt...........................................2
LevelIt............................................2
Ground It............................................2
Adjust It......................................
StartIt .........................................3
,iii,,i ",
CONTENTS
Featuxes .................................................. 3-1..5.6
BeforeCallingforService...........................................6
DefrostIt!QuickDefrost..................................7
Clean It...........................................................7
Energy Savings Tips ................................... 7
Vacation and Moving Care......................7
Warranty ...........................................Back Cover
RG. I RG. 2
WARNING: If freezer is plugged in, unplug the
electrical cord plug from wall outlet.
o Lay freezer on its back on a throw rug.
(Fig 1) Remove base panel by unscrewing. 2
screws from front of base panel° Remove wire
from clips on bottom of cabinet.
o Unplug connector by holding the cabinet
connector in place and pulling door connector
out, then remove the two screws from the
bottom hinge.,
,, (Fig° 2) Lift up plastic hinge cover and fold back.
It is very important that a screwdriver be used
both to loosen and retighten the flat head
screws on the top hinge, to insure a secure
assembly and prevent hinge slippage°
o Remove the top hinge from cabinet, and lift the
door off the cabinet.
To replace door, reverse above order°
5. dL
, ,i i
......... i i1,1
3
INCHES
3 INCHES -./__.
i
Allow three inches of air space on all sides of the
freezer.
• Keep away from flammables, such as gasoline.
- The floor must support the weight of the freezer
when fully loaded,
° Keep away from an oven or other heat source_
Preferably locate in an area below 100°F,
2
\
NOTE: All four-levelers must be reinstalled in
bottom of cabinet after skids are removed.
To Level:
• Screw levelersup as faraspossible
• Adiustlevelersdown untilthecabinetislevel.
• Try tomove or rockcabinettocheckforstability,
o Ifcabinetis"wobbling"adjustlevelsas required
to stabile for a firm installation,
• As a tip, the door will dose
more readily if
front of cabinet is Turn Turn
slightly higher atghtto Lento
than rear. Inspect Lowar Ra_sa
door seal
GROUNDED
_p 3"_RONG
WALL
_,, RECEPTACLE
RONG
I_III ['LUG
DO NOT REMOVE GROUND PLUG UNDER
ANY CIRCUMSTANCES. DO NOT USE AN
EXTENSION CORD.
For your safety and protection, the Kenmore
freezer is equipped with a spedal three:termi'nal
type grounciing plug on the electrical cord. It
must be ptuggea into its own properly grounded
three-prong outletql5 volt, 60 Hertz, protected
with a I5 amp time delay fuse or circuit breaker°
Do not plug the freezer into an outlet controlled
by a wall switch or pull cord which might be
turned off accidentally,
If the electrical outlet you intend to use will not
accept the tbxee-prong plug, or if you are not sure
the outlet is adequately grounded, you should
have a properly grounded three-prong outlet
installed according to the National Electrical Code
by a qualified electridan.
Never unplug your freezer by pulling on the cord_
Alway_s grip the plug firmly and pull straight out
from the receptacle.
Loading ...
Loading ...
Loading ...