Loading ...
Loading ...
Loading ...
Troubleshooting
Problem Cause i Remedy
Circuit breaker on the
mower tripping
Mower not mulching
properly
Mower vibrating at higher
speed
1. Too much workload on the mower.
2. Fuse blown; outlet overloaded.
1. Wet grass clippings stick to the underside of
the deck.
1. Bent motor shaft.
2. Cutting blade is unbalanced.
3. Blade is loose.
1. Raise the cutting height, resetthe circuit
breaker on the mower, take a smaller width
of cut, and walk slowly.
2. Connect to an outlet that is fused for 15
amperes. Reset the circuit breaker and start
the mower again.
1. Wait till the grass dries before mowing.
1. Stop the motor, disconnect the power source
and inspect for damage. Have repaired by an
authorized service dealer.
2. Balance the blade by grinding each cutting
edge equally.
3. Tighten blade bolt to 309 in. Ibs.
19
Loading ...
Loading ...
Loading ...