Loading ...
Loading ...
OPERATION
HOW TO USE TOOLS
CAUTION: To reduce the risk of injury
from moving parts - Unplug before connecting
SpinScrub® Hand Tool. Not to be used for
grooming pets.
1
Place the handle in the upright position. This will
shut o the SpinScrub® brushes.
2
Connect tool to hose by sliding it onto the
connector until it locks into place.
3
Using your thumb, push forward and up on the
latch to remove tool.
NOTE: The Antimicrobial pet tool included with
select models only has a button to release the
tool from the hose.
4
Turn cleaner ON.
5
Pre-spray the carpeted stair by holding the tool
about one inch above the carpet and push it
forward while pressing the trigger.
6
Position tool against the riser and slightly press
it into carpet pile. Press the trigger and pull the
tool slowly over the carpet. Release trigger at
end of stroke.
7
Lift tool, and position it against riser. Pull tool
slowly over carpet without pressing trigger.
NOTE: Overlap strokes by 1/2 inch to help prevent
streaking.
MAINTENANCE
WARNING: To reduce the risk of
personal injury, unplug before cleaning or
servicing.
IMPORTANT: To prevent possible
leaking, remove Clean Water Tank and Dirty
Water Tank.
This product contains no serviceable parts.
If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into
water, call customer service at 1.800.944.9200
prior to continuing use.
LUBRICATION:
The motor is equipped with bearings which
contain sucient lubrication for their lifetime.
The addition of lubricant could cause damage.
Do not add lubricant to motor bearings.
CORD STORAGE:
Wrap the power cord around the cord hooks
for convenient storage. Attach the plug end to
the cord.
NOZZLE CARE
1
First turn o and unplug the carpet cleaner.
Remove Recovery Tank.
2
Pull up on the Nozzle slightly to unsnap, then
pull the Nozzle forward to remove it from carpet
cleaner. Rinse with water and allow to air dry.
3
To replace it, position Nozzle onto the front end
while making sure to align the tabs at the bottom
of the Nozzle with the notches on the foot.
4
Snap Nozzle to foot and rotate the latch into the
lock position.
IMPORTANT: The nozzle must be in the proper
position for the Dirty Water Tank to go on properly
and for the unit to have proper suction.
BRUSH CARE
1
Remove the tanks and place the handle in the
upright position, tilt the cleaner back until handle
rests on the floor.
2
Push the latches out on the side of the foot until
they lock open.
3
The Brush assembly should be free to pull out.
4
Rinse the brushes under running water.
5
Replace them by aligning the center drive post
and note the arrows indicating the front of the
machine. Push firmly until the latches lock into
place.
TROUBLESHOOTING
WARNING: To reduce the risk
of personal injury, unplug before cleaning
or servicing.
CAUTION: To reduce the risk of
injury from moving parts - Unplug before
servicing. Do not use cleaner without
brushes in place.
THIS PRODUCT CONTAINS NO SERVICEABLE
PARTS.
IF APPLIANCE IS NOT WORKING AS IT SHOULD,
HAS BEEN DROPPED, DAMAGED, LEFT
OUTDOORS, OR DROPPED INTO WATER, CALL
CUSTOMER SERVICE AT 1-800-944-9200 PRIOR
TO CONTINUING USE.
Loading ...
Loading ...
Loading ...