Loading ...
Loading ...
Loading ...
• Theamountofdetergenttousedependson:
Howmuchsoilremainsontheitems-Heavilysoiledloads
requiremoredetergent.
Thehardnessofthewater- Ifyouusetoolittleinhardwater,
disheswon'tbeclean.Ifyouusetoomuchinsoftwater,
glasswarewilletch.
SofttoMediumWater(0-6grainsperU.S.gallon)
[typicalwatersoftenerwaterandsomecitywater]
MediumtoHardWater(7-12grainsperU.S.gallon)
[wellwaterandsomecitywater]
• Dependingonyourwaterhardness,filltheMainWashsection
ofthedispenserasshown.FillthePre-Washsectiontothe
levelshown,ifneeded.
NOTE:Fillamountsshown
areforstandardpowdered
detergent.Follow
instructionsonthepackage
whenusingotherdishwasher
detergent.
N HardWater I(
\ _ _ HardWater
NainWash Pre-Wash
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good
drying performance. Without rinse aid your dishes and _ Full
dishwasher interior will have excessive moisture. The heat
dry option will not perform as well without rinse aid.
• Rinse aid keeps water from forming droplets that can
dry as spots or streaks. It also improves drying by k_ Adc
allowing water to drain off of the dishes after the final
rinse.
Rinse aid helps to reduce excess moisture on the dish racks
and interior of your dishwasher.
Check the rinse aid indicator. Add rinse aid when indicator
drops to "Refill" level.
To add rinse aid, turn the dispenser
cap counterclockwise and lift off.
Pour rinse aid into the opening until
the indicator window looks full.
Replace the dispenser cap and turn
clockwise. Make sure cap is fully
locked.
USERINSEAIDFOR FuU
OpenBETTER__DRY(NGLock !
STEP 3
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
cycles
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
options
@ locked 2 /_ _;
hold to lock
STEP 4
Start or Resume a Cycle
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the same @start
cycle and options as in the previous wash cycle. _.....
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Lights will stop flashing when the door is properly shut. Press
the START/RESUME button and after a slight delay, the cycle
will resume at the point of interruption.
NOTE: For most water conditions,
the factory setting of 2 will give good
results. If you have hard water or
notice rings or spots, try a higher
setting. Turn the arrow adjuster
inside the dispenser by either using
your fingers or inserting a flat-blade
screwdriver into the center of the
arrow and turning.
¼ turn to lock
Loading ...
Loading ...
Loading ...