Loading ...
Loading ...
Loading ...
2. Attach REAR bar using SIXTH and EIGHTH holes in
bar.
NOTE: Remove screws from Table Extensions ... the ones
closest to the table. Reinstall them after attaching guide
bar. If extension is used on right side of saw, remove the
Guide Bar Rod.
t -J
/1 _/-- "----_
INSTALLING BLADE GUARD
1. From among the loose parts, find
2 Hex Head Screws, 1/4 in. - 20 x 5/8 in. long
2 Hex Head Screws, 5/16 in. - 18 x 5/8 in. long
2 Hex Head Screws, 5/16 in. - 16 x 1 in. long
2 Hex Nuts, 1/4 in, - 20
(approx. dia. of hole 1/4 in.)
2 Lockwashers, 1/4 in. External Type
(approx. dia. of hole 1/4 in.)
2 Lockwashers, 5/16 in. External Type
(approx. dia. of hole 5/16 in.} ....
1Thumbscrew
Blade Guard Support
Spreader Support
Spreader Rod
2. Lower the blade.
3. Screw the two MOTOR MOUNT CLAMP SCREWS part
way into cradle.
4. Attach BLADE GUARD SUPPORT ... DO NOT
TI GHTEN screws.
LADE
Insert SPREADER ROD into SPREADER SUPPORT
until pin fits into notch. Insert Thumbscrew and tighten
it.
SPREADER
ROD
\
FLAT
SURFACE
(INTO SUPPORT)
u
SPREADER
SUPPORT
14
Loading ...
Loading ...
Loading ...