Loading ...
Loading ...
Loading ...
5
LOCATION OF PARTS
Shelves (3)
Bottom Grille
Adjustable Legs
LED Light
Security Lock
Door
Handle
Digital Control Panel
INSTALLATION INSTRUCTIONS
• Remove the exterior and interior packing.
BEFORE USING YOUR APPLIANCE
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door, if it is not already attached. (See page 7.)
• The appliance is designed for built-in or recessed or free-standing installation for indoor use.
INSTALLATION OF YOUR APPLIANCE
• CAUTION: This appliance is not designed for the storage of medicine or other medical products.
• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
• For free standing installation, 5” (127mm) of space between the back and sides of the unit, and 4”
(102mm) at the top, are suggested, which allows the proper air circulation to cool the compressor and
condenser. Even for built-in installation, it is a must to keep ¼” (6.35mm) space on each side and at
the top and 2” (51mm) at the rear. Take care that the air vent at the front of the appliance is never
covered or blocked in any way.
Loading ...
Loading ...
Loading ...