Loading ...
Loading ...
1
2
CARTRIDGE RELACEMENT
Shut off water supplies!
Loosen the screws(2) and raise the
faucet(1). turn the tubes(3) clockwise.
Loosen the cartridge nut (1) and
Remove the old cartridge (2) and
replace with the new cartridge. Replace
the cartridge nut (1) .
CARE AND CLEANING INSTRUCTIONS
Congratulations on your purchase of an Elkay product. Although
your product is extremely durable, attention should be given to the
care, cleaning and maintenance of this product. Cleaning agents
and abrasives may cause damage, which may result in oxidation
and discoloration.
By following these simple guidelines for proper care and cleaning, it
will give you years of enjoyment:
TO CLEAN: Simply wipe gently with a damp cloth and blot dry with
a soft towel.
A common rule of thumb is:
when you dry off your hands, dry off your product.
·
Avoid build-up of soap, toothpaste or mineral deposits, as these
tend to have an adverse effect on the appearance of the product.
·
NEVER use cleaning products of any kind on this product -
especially those containing ammonia, bleach or alcohol - or those
with any form of abrasive.
FOR CARE AND MAINTENANCE:
·
The water in certain areas of the world can be very caustic -
standing water around the product can cause damage. Be
sure to remove standing water with a dry, soft cloth as soon
as possible.
·
Before applying a protective coating, gently brush the entire
fixture using a soft tooth brush. This will remove any dirt or
deposit build-up.
·
These simple steps will add temporary protective coating to
your faucet and extend the life of the finish.
Failure to follow care and cleaning will void your warranty.
For additional information, please visit elkayusa.com.
Turn the tubes (3) counterclockwise and
reinstall the faucet(1). Tighten the
screw (2). Do not overtighten.
Note: Install cartridge correctly for
proper handle rotation.
The faucet ships with a 1.5GPM aerator installed. An
optional 2.2 GPM aerator is also included in the box.
To switch the flow rate of the faucet:
1. Disassemble the quick connect assembly by
separating the connector (1) and quick connect (2).
2. Replace 1.5 GPM connector(green) with the 2.2GPM
connector.
3. Reinstall quick connect assembly.
1
1
2
1
2
FLOW REGULATOR REPLACEMENT
1
2
3
1
2
3
CW to loosen
CCW to tighten
Loading ...