Loading ...
Loading ...
Loading ...
Aboutthe automatic icemaker, ge.com
A newly installed refrigerator may take 12to 24 hours to begin making ice.
Automatic Icemaker
Power
Switch Icemaker
PowerLight _rArm
The icemaker will produce seven cubes
per cycle----ai)i)roxin/ately 100-130 cubes
in a 24-hour period, depending on fl'eezer
coi//l)ai'tillent tei//l)ei'attli'e _ i'ooi//
temperature, number of door openings
and other use conditions.
See below fin" how to access ice and reach
the power switch on dispenser models.
If the reti_igerator is operated betore the
water connection is made to the icemakei;
set the power switch in the 0 (off) position.
When the refl-igerator has been connected
to the water supply, set the power switch to
the I (on) position.
The icemaker will fill with water when it
cools to 15°F (-10°C). A newly installed
refi_igerator may take 12 to 24 hours to begin
making ice cubes.
You will hear a buzzing sound each dine
the icemaker fills with watei:
Throw awm the first tew batches of ice to
allow the water line to clem:
Be sure nothing interteres with the sweep
of the feeler ram.
When the bin fills to the level of the teeler
ram, the icemaker will stop producing
ice. It is nomml fin" several cubes to be
joined togethei:
If ice is not used fl'equenfl> old ice cubes
will become cloudy, taste stale and shrink.
NOTE."In homeswith lower-than-averagewater
pressure,you may hear the icemaker cycle multiple
times whenmaking one batch of ice.
Models without a shelf
above the ice bin
Toaccessice andreach the
icemakerpower switch:
o Lift flTebin, then pull it
forward until the bin stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice bin, only store items
on the shelf below the ice bin that
are no taller than the Iowest poflTt
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf aboxe
the bin, the other does not.
Special note about dispenser models
without a shelf above the ice bin:
ii;:These models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself
up while you take ice out or turn the
icemaker power switch on and off.
Be sure to put the bin back in place
before ch)sin_* the (looI:
To restore your ice level from an empty
19 houi_ atter the fii_t batch ofice
O
has fidlen into the bin, dispense
3 to 4 cubes.
@ _Mter an additional 6 horns, dispense
3 to 4 cubes again.
Models with a shelf
above the ice bin
Toaccessice, pullthe binforward.
Toreach the power switch, pull the
shelf straight out Always be sure to
replace the shelf.
These steps will restore your ice level
in the shortest ai//otint of time.
11
Loading ...
Loading ...
Loading ...