Loading ...
Loading ...
Loading ...
Setting Warmer Drawer Controls
Warmer (Warm & Ready TM) Drawer Indicator Light (some models)
The indicator light is located above the warmer drawer thermostat control. It turns on when the control is set, and stays
on until the control is turned off. The warmer drawer is inoperable during the self-clean cycle. The indicator light will not
come on during the self-clean cycle.
Removing and Replacing Warmer Drawer (some models)
Pullupwith firmer
Pushdownwithfinger
Figure I
ii i!ii!ii !iiiiTM %
li iTM ! !!Ci:i :
Figure 2
To Remove and Replace Warmer (Warm & Ready TM) Drawer
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you wilt find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locate glide lever on each side ofdrawer, pull up on the left glide lever and push
down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide ofthe drawer body.
2. Pull the bearing glides to the front of the chassis glide (see figure 2).
3. Align the glide on each side ofthe drawer with the glide slots on the range.
4. Push the drawer into the range until levers "click" (approximately 2"). Pullthe
drawer open again to seat bearing glides intoposition.If you do not hear the
levers "click" orthe bearing glides do not feel seated remove the drawer
and repeat steps 2-4. This wilt minimize possible damage to the bearing
glides.
_!,W-'I:t_11#[_11Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
16
Loading ...
Loading ...
Loading ...