Loading ...
Loading ...
Loading ...
17
8. SETTING THE WATER SOFTENER (DEPENDING ON MODEL)
1. Press the Cycle Select button before you switch the appliance on and keep this button pressed down.
2. Switch the appliance on using the On/Off button; then release the switch.
3. Hold the Cycle Select button down for 10 seconds until the control indicator on the Start/Pause button
begins to flash.
4. Water hardness can be set to the desired level by pressing the Cycle Select button (compare the test
strip with the degrees of Hardness Table). The appropriate program follows and lights up.
5. Once you have set the hardness level, press the Start/Pause button to save the value. The control
indicator on the Start/Pause button now lights up permanently.
6. Switch the appliance off again using the On/Off button.
HARDNESS TABLE
Notice:
• If the water hardness level is less than 7 American degree of hardness, you do not need any special
softening salt. In this case, the “salt” control indicator lights up continually (depending on model).
• If your local hardness level exceeds 47 American degree of hardness, you should consider getting a
water softening device for your dishwasher. If you use stream water or rainwater, you are advised to
install filters.
• If you move, do not forget to adjust the water hardness level to suit your new neighborhood.
Loading ...
Loading ...
Loading ...