49-50327 03-17 GEA
About the GE Appliances MWFA water filter cartridge
Water filter cartridge
The water filter cartridge is located in the back upper right corner
of the refrigerator compartment.
When to replace the filter on models with a
replacement indicator light
There is a replacement indicator light for the water filter cartridge
on the dispenser. This light will turn orange to tell you that you
need to replace the filter soon.
The filter cartridge should be replaced when the replacement
indicator light turns red or if the flow of water to the dispenser
or icemaker decreases.
When to replace the filter on models without a
replacement indicator light
The filter cartridge should be replaced every six months
or earlier if the flow of water to the dispenser or icemaker
decreases.
Removing the filter cartridge
If you are replacing the cartridge, first remove the old one by
slowly turning it to the left. Do not pull down on the cartridge. A
small amount of water may drip down.
CAUTION
To reduce the risk associated with
property damage due to water leakage, read and follow
instructions before installation and use of this system. Installation
and use MUST comply with all state and local plumbing codes.
Installing the filter cartridge
1. Fill the replacement cartridge with water from the tap to allow
for better flow from the dispenser immediately after
installation.
2. Line up the arrow on the cartridge and the
cartridge holder. Place the top of the new
cartridge up inside the holder. Do not push it
up into the holder.
3. Slowly turn it to the right until the filter
cartridge stops. DO NOT OVERTIGHTEN.
As you turn the cartridge, it will automatically
raise itself into position. The cartridge will
move about a ½ turn.
4. Run water from the dispenser for 1-1/2 gallons (about three
minutes) to clear the system and prevent sputtering.
5. Press and hold the RESET WATER FILTER pad (on some
models) on the dispenser for three seconds.
NOTE: A newly installed water filter cartridge may cause water to
spurt from the dispenser.
Filter bypass plug
You must use the filter bypass plug when a replacement filter
cartridge is not available. The dispenser and the icemaker will not
operate without the filter or filter bypass plug.
To use the filter bypass plug on Water by Culligan
™
models, you
must first remove the filter adaptor from the cartridge holder by
turning it to the left.
ridge
older
Cartridge
Holder
SmartWater
Filter Bypass
Plug
Filter Bypass
Plug
ter
ss
ug
Water by Culligan
To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small
parts during the installation of this product. The disposable filter cartridge should be replaced every 6 months at the
rated capacity, or sooner if a noticeable reduction in flow rate occurs.
For the maximum benefit of your filtration system, GE Appliances recommends the use of GE-branded filters only. Using GE-branded
filters in GE Appliances and Hotpoint
®
refrigerators provides optimal performance and reliability. GE Appliances filters meet rigorous
industry NSF standards for safety and quality that are important for products that are filtering your water. GE Appliances has not
qualified non-GE-branded filters for use in GE Appliances and Hotpoint refrigerators and there is no assurance that non-GE-branded
filters meet GE's standards for quality, performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at www.gewaterfilters.com or call
GE Appliances Parts and Accessories, 877.959.8688. In Canada, call 866.777.7627.
WARNING
GE is a trademark of the General Electric Company. Manufactured under trademark license.
34-8720-0895-7
Loading ...
Loading ...
