Loading ...
Loading ...
Loading ...
EN - 16
corresponding to the status of the
programme in operation. While the
Drying symbol is displayed, the machine
will remain silent for 45 to 50 minutes.
The Remaining Time Display shows
the programme durations and the time
remaining of the programme in operation.
NOTE: A programme may take a
different amount of time to complete
than initially stated on the display. This is
dependent on the ambient temperature, the
temperature of the mains water, and the
amount of dishes in the dishwasher.
-Press the Start/Standby button (2).
-Select a new programme using the
Programme button (4).
-Press the Start/Standby button to start the
selected programme.
-The new programme will resume the
course of the old programme.
7.2. Cancelling a Programme
Follow the steps below to cancel a
programme while in operation.
• Press and hold the Start/Standby button
(2) for 3 seconds.
• The display will count down from 3 to 1.
When it finishes, the time remaining for
cancellation will show on the display.
The water discharge process will start when
the remaining time finishes and the End
symbol will illuminate.
=
7.3. Switching Off the Machine
When the End symbol illuminates, switch
off your machine using the On/Off button.
Disconnect the plug and turn off the water
tap.
NOTE: Do not open the door before the
End symbol illuminates.
NOTE: Leave the door of your
machine slightly open at the end of a wash
programme to speed up drying.
NOTE: If the door of your machine
is opened or the power is cut during
operation, the programme will continue
when the door is closed or the power
returns.
NOTE: Simultaneously press the Half
Load (3) and Tablet Detergent (5) buttons
for 3 seconds to activate/deactivate the
Child Lock. When it is first activated, “CL”
will show on the Remaining Time display for
2 seconds. When it is deactivated, “CL” will
flash twice.
NOTE: When there is insufficient rinse
aid, the Rinse Aid Lack Warning symbol
(12) will illuminate to indicate the rinse aid
chamber needs filling.
7.
THE CONTROL PANEL
7.1. Changing a Programme
Follow the steps below to change
a programme while in operation.
Loading ...
Loading ...
Loading ...