Loading ...
Loading ...
Loading ...
Installation
Leveling
Notes:
• Complete any required water supply connection
before leveling.
• Some models only have adjustment screws (A).
Materials Needed:
• %" hex head driver
• Carpenter's level.
1. Remove toe grille.
• Grasp firmly and pull -- J
outward to unclip.
2. Using hex head driver, turn
the front adjustment screws (A) on each side to
raise or lower the front of the refrigerator (see
illustration below).
c c
3. Select models also have rear adjustment screws
(B). Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
.
Using a carpenter's level, make sure front of
refrigerator is '/4"(6 ram) or approximately '/2bubble
higher than back of refrigerator and that the
refrigerator is level from side to side.
Turn stabilizing legs
(C) clockwise until
firmly against floor.
Turn adjustment screws
(A) counterclockwise
to allow the full weight
of the refrigerator to
rest on the stabilizing
legs.
If required, correct
rocking of refrigerator
by turning rear
adjustment screw
clockwise to raise
rocking corner. If doors
are uneven, do the following:
RollerAdjustmen! Screw
I
e Stabilizing
o Leg
O
• Determine which door needs to be raised.
Turn front roller adjustment screw (A) clockwise
to raise front corner of door.
If one refrigerator door has reached the limit of
its adjustment range and doors are still not level,
raise or lower the opposite door by turning roller
adjustment screw clockwise or counterclockwise.
Check with level to verify 6 mm tilt to the back
for proper door closure.
• If refrigerator is aligned and stable, replace toe
grille.
• Align the toe grille mounting clips with the lower
cabinet slots.
Push the toe grille firmly until it snaps into place.
Loading ...
Loading ...
Loading ...