Loading ...
Loading ...
Loading ...
Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary, before and after
installation.
MOUNTING OPTION
CAUTION
Upper Jam
Screw
Upper Jam
Screw
Do not loosen two lower jam screws
Bolt
Yolk
Yolk
Flat Washer
Cotter
Pin
INST
INST
ALLA
ALL
A
TION
TION
1.
Fig. 2a
Fig. 2b
Fig. 2c
DOWNROD MOUNT
-
Using
a
Philips
sc
rewdriver
loosen the
two
upper
jam
sc
r
ews
on
the
yoke.
-
Position down
rod inside canopy.
-
Route wir
es
exiting yoke on motor through ceiling
canopy
and
down
r
od.
- Position down
r
od/canopy into
yoke and
align holes
in
yoke
and
down
r
od.
- Inse
r
t bolt through
hole
in yoke and downrod.
Be
careful
not
to
damage
or
cut
the
fan wires.
- Tighten flat washe
r
, lock washer
,
and nut and bolt (not included on
some
models
).
Secu
r
e
with cotter pin through hole in the end of the
bolt.
- Secure downrod in position by tightening upper jam screws.
A
FLUSH MOUNT
- Remove the yoke screws and lockwashers which correspond to the holes
- Optional for some models -Remove rubber ring from canopy (see Fig. 2d)
in the canopy.
- Position canopy over the holes on motor and secure with the same screws
and lockwashers removed in the previous step. Ensure to place the rubber bushing
between the canopy and motor.
B
Pg. #9
MOUNT BLADE
BRACKETS
TO
BLADES
6.
- Place blade bracket screw through flat washer, fibre washer and blade.
- Align with corresponding hole in blade bracket.
- Repeat with (2) remaining screws and tighten.
Blade
Bracket
Fibre Washer
Flat Washer
Fig. 8
Blade Bracket Screw
- Insert the blade arm into the fan as shown.
- Tighten the blade arm to motor with the screw and lock washer as shown.
- Slightly turn the blade after installation and repeat the same step for the other blades.
MOUNTING
BLADES TO
MOTOR
7.
Fig.9
Fig. 2d
Fig. 2e
Canopy
Rubber Ring
Motor
Canopy
Yoke Screws
& Washers
Rubber Bushing
Loading ...
Loading ...
Loading ...