Loading ...
Loading ...
Loading ...
PART 1: HOOD INSTALLATION GUIDE
11
STEP 6:
Secure the hood to the wall by screw xing through the ve (5x) holes on the
horizontal plate of the Mounting Bracket.
STEP 7:
Secure the Chimney Bracket to the wall.
STEP 8:
Refer to Part 2: Motor Installation Guide.
STEP 9:
Place the stainless steel chimney on the hood and secure to the Chimney Bracket
with the two (2) screws supplied. If the chimney is required to be shortened, new
holes may need to be drilled to secure the chimney cover.
STEP 10:
Attach the male power plug of the rangehood unit to mains power supply. Note to
electricians: Standard 10 Amp General Power Outlet (GPO) required. Position GPO
as close to the hood unit as possible.
INSTALLING THE GREASE TRAP AND BAFFLE FILTERS:
All WHISPAIR hoods utilise removable bafe lters and grease trap. This ltration
system is used to catch by-products such as grease and moisture from the air ow.
To install the bafe lters, simply locate the lter on the top ledge of the hood and
then slide the lter on a downward angle to rest in the channel of the grease trap.
Ensure the lter vane are aligned towards the rear of the hood.
Most by-products are captured and stored directly in the bafe lters however the grease trap may begin to ll when excess amounts of
grease and condensate build up in the lter vanes.
The grease trap can be removed for cleaning by removing the two (2) screw xings in the channel.
To clean your bafe lters and grease trap please wash with warm soapy water or simply place in the dishwasher for convenience. Please
note, baffle filter edge's can be sharp and caution must be taken when removing and when cleaning by hand.
It is recommended the bafe lters and grease trap are cleaned every 4 weeks to reduce the risk of re.
Chimney Bracket Chimney Fixing Points
Bafe Filter and Grease Trap Position
Top Ledge
Bafe Filter Grease Trap
Front Rear
Step 9: Chimney Installation
Loading ...
Loading ...
Loading ...