Loading ...
Loading ...
Loading ...
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Is the automatic cycle ending early?
The load may not be contacting the sensor strips. I.evel the dryer.
Change the dryness [eve[ setting on Sensor Cycles. Increasing or decreasing the dryness
[eve[ will change the amount of drying time in a cycle.
Lint on load
• Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
• Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
I)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
Select Custom Refresh cycle to tumble the load with water and heat to help smooth out
wrinkles from a load [eft in the dryer.
Was the dryer overloaded?
Dry smaller loads that can tumble freely. Smaller loads yield best results with the Rapid
Refresh Small I.oad cycle. Results may also vary depending on fabric type. This cycle is
best for reducing wrinkles and odors from loads consisting of wrinkle-free cotton, cotton
polyester blends, common knits, and synthetics.
Odors
Have you recently been painting, staining, or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
To remove odors left in garments after wearing, select the Rapid Refresh Small I_oad cycle
for small loads of two to four garments. This cycle is best for reducing wrinkles and odors
from loads consisting of wrinkle-free cotton, cotton polyester blends common knits, and
synthetics.
Loading ...
Loading ...
Loading ...