Loading ...
Loading ...
Loading ...
18
Dishwasher Control Section
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When Locked is lit, all buttons are
disabled. The dishwasher door can still be opened or closed while the controls are locked.
To turn on Control Lock:
Press and hold SANI RINSE for 3 seconds. The indicator will light up. If you press any button while your dishwasher is locked, the
light ashes three times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off Control Lock:
NOTE: You may need to disable Sleep mode by pressing either START/RESUME or CANCEL/DRAIN or by opening and closing
the door before you are able to turn o Control Lock.
Press and hold SANI RINSE for 3 seconds. The light turns o.
Delay Hours
Use this option to run your dishwasher during o-peak hours. Local utility providers recommend using energy during o-peak
hours when possible. Delay displays how many hours before the cycle will begin.
To delay the start:
1. Select a wash cycle and options.
2. Press DELAY HOURS to choose the number of hours to be delayed.
3. Press START/RESUME to begin the delay countdown.
NOTE: Anytime the door is opened for more than a few seconds (such as, to add a dish), you must press the Start/Resume
button again and close the door within 4 seconds to resume the delay countdown.
Dishwasher Feedback Section
Cycle Indicators and Time Display
The Cycle Status lights will glow for Washing, Drying, Sanitized, and Complete.
They also glow when the control is locked and/or the delay option is selected.
The status display is used to follow the progress of the dishwasher cycle and to show
other information.
Estimated cycle time is displayed in hours and minutes as you make cycle and option
selections. After you start the dishwasher, the display counts down the time.
When you select the Delay option, the time display will give the number of hours
followed by an “H”.
The status light on the front panel is blue when washing, red when drying, and white
when the cycle is complete.
Selecting Cycles and Options
1. To repeat the same cycle and options used on the previous cycle, press START/RESUME once to show which selections you
used. Press START/RESUME again and close the door within 4 seconds to run the cycle. If the door is not closed in time, the
dishwasher will beep several times and will not start.
2. To start a new cycle, select the desired cycle and options, then press START/RESUME and close the door within 4 seconds
to run the cycle. If the door is not closed in time, the dishwasher will beep several times and will not start. Not all options
are available for every cycle. If an invalid option is selected for a given cycle, the lights will ash.
Turning On/Off the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound on and o. The sound will not be deactivated for cycle interruption.
Loading ...
Loading ...
Loading ...