Loading ...
2
NOTE: The water tubing is built into the fountain. Take care when handling the water tube; detaching the
water tube from the fountain will damage the fountain and void the product warranty.
ASSEMBLY:
1. From the access panel in the back of the fountain, locate the built-in water
tube and light cable. Extend the LED light cable and connect the AC
adapter. Connect the pump to the water tube and place the pump inside
the fountain.
2. Run the pump power cable out the back of the fountain. Align the cables
with the groove in the access panel cover, as shown.
3. Twist the access panel cover to secure it to the back of the fountain.
4. Fill the fountain with enough water to keep the pump fully submerged
during operation, approximately 5 gallons.
5. Plug both power cords into properly grounded GFCI outlets.
Note: When rst used, there may be air in the pump.
It may take several minutes for trapped air to escape, allowing water to ow.
1
2
3
4
5
Sponge-like polyurethane foam
lters help control water ow
and prevent splashing ― do not
remove these guards as doing
so may result in splashing and/
or leaking.
3
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin
as needed.
• Check to make sure the power outlet is working; if in doubt about
electrical connections, consult a certified electrician.
• Check the pump and tubing for obstructions.
• Check the flow control on the body of the pump as it may need to be
adjusted to achieve the desired flow rate.
• If the lights are not working, ensure the cables are fully connected, and
the seals are adequately tightened (do not over-tighten).
• If water is not flowing within several moments of the fountain being
plugged in, unplug the power supply for a few moments and plug it
back in; the pump may have air bubbles in the filter which can prevent
water from circulating properly.
USE & CARE
• Recommended for outdoor use only. Some splashing is normal; adjust
the flow rate on the pump if the water rate is too high.
• Check the water level frequently to ensure the pump remains fully
submerged; never allow the pump to run dry as it will burn out the motor.
• Only use water in this fountain; distilled water will help prevent mineral
buildup but is not required.
• Periodically change the water to keep the water, fountain and pump
clean. Remove scale and build-up regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use anything abrasive to scrub the fountain.
DO NOT use a pressure washer.
• Always shut off the power supply before cleaning and maintaining the
fountain and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the
pump, never the power cord.
• During freezing weather, drain the fountain, disconnect the pump and
store indoors; allowing ice to form will damage the fountain.
IMPORTANT INFORMATION
Any modication to the product or failure to follow
recommended care will void the product warranty.