Loading ...
Loading ...
Loading ...
12
1. Pry up the hinge cover (1) and hinge cap (2) using a flat head screwdriver.
Using a Phillips head screwdriver, loosen the hinge screws (3a) and remove
the top hinge (4). You can now lift the door (5) off the bottom hinge and set
it off to one side. Be careful not to lose the washer (11) between the
bottom hinge and the door. You will need this later. Also remove lock hole
cap (6) and screws (7) and (8) from the top of the door. The lock cap can
be pried up using a small flat head screwdriver.
2. Using a Phillips head screwdriver, loosen screws (3b) to remove the hinge
support rod (9) at the bottom of the door. Rotate the door 180° so that the
top is now the bottom and vice versa. Attach the bottom hinge support rod
(9) to the bottom corner of the door and attach with screws (3b).
3. Using a flat head screwdriver, pry off the bottom hinge cover (12). Using a
Phillips head screwdriver, loosen and remove screws (3c) and (13) and
bottom hinge (10).
4. Move bottom hinge (10) to the opposite side and re-insert all screws (3c)
and (8). Bottom hinge cover (12) should clip back onto the bottom hinge.
5. Place the washer (11) over the hinge support rod (9) and place the door
back on the bottom hinge by aligning the hinge support rod (9) with the
outer hinge hole on bottom hinge (10).
6. Re-attach top hinge (4) using screws (3a). Insert lock cap (6), screws (7)
and (8), and clip on hinge cap (2).
Installing the Handle
1. Pull back the door seal behind handle location.
2. Insert screws into pre-drilled screw holes.
3. Attach handle and tighten screws.
4. Press door seal back into place.
Loading ...
Loading ...
Loading ...