Loading ...
Loading ...
Loading ...
Check periodically for signs of
overheating or deformations of
the plug. If any overheating or
deformation occurs, immediately
discontinue using the heater and
contact Dr. Infrared Heater
Authorized Service Center.
20. CHECK YOUR HEATER CORD
AND PLUG CONNECTIONS.
Faulty wall outlet connections or
loose plugs can cause the outlets
or plug to overheat. During use,
please check frequently to
determine if your plug outlet or
faceplate is HOT! If so,
discontinue using the heater
and/or have a qualified electrician
to check and replace the faulty
outlet(s).
CAUTION: This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
SAVE THESE
INSTRUCTIONS
Operating Instructions
1. Plug the power supply cord into a
grounded wall outlet (120VAC,
60Hz).
Important: This heater is for use on
120 volts and comes with a grounded
(three-prong) plug. The grounded plug
must be used with a grounded outlet.
Do not use an adapter in a two-slot
wall outlet unless the ground plug of
the adapter properly connects to a
building ground. Using the heater
without a properly grounded outlet or
adapter could result in an electric
shock hazard. The cord has a plug as
shown at A in the figure below. An
adapter as shown at C is available for
connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
2. TURNING THE HEATER ON
To turn the heater ON, press the
Power button; the power LED will
turn on. Next, press the MODE
button; the heat setting will be set
to AUTO. Press the MODE button
again to set to HIGH. Press the
button a third time to set to LOW.
Press the button a fourth time to
turn the heater OFF.
3. TURNING THE HEATER TO
POWER OFF To turn the heater
to POWER OFF, press the Power
button. The power LED and the
temperature LED will turn off.
Loading ...
Loading ...
Loading ...