Loading ...
Loading ...
Loading ...
11
High Pressure Pump Oil: Th
e preferred oil is SIMPSON
®
Premium Pump
Crankcase Oil. If this oil is not available, an SAE 15W-40 oil may be used. Change
the pump oil after the first 50hours of operation and every 100 hours thereafter, or
every 3 months.
Gasoline Engine Oil:
Check engine oil level before each use. Refer to the
Engine
Owner's Manual
for correct procedure.
12V DC Battery:
The 12V DC battery operates the engine's electrical start system,
after the engine is started the system will charge the battery and operate the burner.
The 12V battery will need to be replaced regularly to ensure consistent performance.
Recommended battery size:
Group 24 battery
Burner Assembly: A device used to change fuel to heat energy. It is used to heat
the water in the coil assembly and is designed to use a NO. #2 diesel fuel.
BTU (British Thermal Unit): The amount of time it takes to raise the
temperature of one pound of water by one degree Fahrenheit.
Back Flow Preventer: Prevents backflow into a potable water system.
WARNING: To reduce the possibility of contamination always
protect against backflow when connected to a potable water system
Pressure Switch: A switch which uses a pressure activated plunger to activate
a microswitch, used to control the fuel solenoid in the burner system.
Flow Switch: A switch which responds to changes in water flow, water
flow moves a magnet which ativates a reed or microswitch to control voltage to
the fuel solenoid in the burner system.
Chemical Injection System: Mixes cleaners or cleaning solvents with the water to
improve cleaning effectiveness.
High Pressure Hose: Only use a wire braid hose rated for the output pressure
and temperature of the high pressure pump. See Specification Insert for the
maximum temperature. Additional hose lengths can be added with quick twist
couplers with a minimal loss in pressure of about .5 PSI per foot. Always inspect
hoses for wear and replace if necessary. Avoid kinking or running over the
hose to extend the hose life.
Hour meter: The analog hour meter operates whenever the engine is running and
keeps track of how many hours the unit has been used.
Water Supply: The minimum requirements for a water supply are 20 psi and
5 Water Supply: The minimum requirements for a water supply are 20 psi at
twice the stated water volume for the machine. If your water source is a well, the
garden hose length can only be 30ft. (9m) maximum.
Loading ...
Loading ...
Loading ...