Loading ...
Loading ...
Loading ...
12 installation
ALIGNING THE REFRIGERATOR DOORS
CAUTION
Risk of electric shock! Before removing top hinge cover
• Shutoffthewatersupplytotheappliance.
• Unplugtheapplianceorswitchoffthefuse.
If the refrigerator doors are not properly aligned
1. Unscrew the top hinge cover and raise the panel
Do not disconnect any harness wire or water tube!
15
2. Loosen the fastener counterclockwise, move the hinge
sideway to adjust the refrigerator door.
Do not remove the fastener!
15
3. Tighten the fastener and replace the top hinge cover.
ADJUSTING THE FREEZER DRAWER
If the freezer drawer is not even.
1. Loosen the two side fasteners.
Do not remove the fasteners!
2. Use the top fastener to adjust the freezer drawer.
3. If level of freezer drawer is proper, tighten the two
side fasteners.
15
FRONT COVER
After installation and/or door leveling, fasten front cover
with screws. (Remove the screws on the front bottom
panel first. Click and screw the cover).
CAUTION
The front of refrigerator needs to be just a little higher than
the back for easy door closing, but if the wheel is raised
too much for door balance, i.e. the front of refrigerator is
much higher than the back, it can be difficult to open
the door.
INSTALLING THE HANDLES
1. Remove the handles from the packaging
2. Fit the refrigerator door first (A) by aligning the handle
with the mounting locations on the door. (as shown
below) ensuring that the handle end marked “TOP” is
aligned with the top mounting location on the door.
3. Pull the handle down until you hear a “click”
4. Repeat this with the other refrigerator handle.
A (refrigerator handles)
5. Next,fitthefreezerhandle(B).(modelWHE5100SAonly)
B (freezer handle)
6. Align the freezer handle with the mounting location on
the freezer door, ensuring that the end marked “Right” is
aligned with the mounting location on the right side of
the door.
7. Pull the handle to the left until you hear a “click”
8. Clean your refrigerator thoroughly following the
instructions on page 15 and wipe off any dust that has
accumulated during shipping.
9. Plug your refrigerator straight into its own power point
and never use a double adapter.
10. Before you put any food in your refrigerator, it is
recommended you leave it on for 2 or 3 hours to check
it is running properly and the appropriate temperature
is reached.
Loading ...
Loading ...
Loading ...