Loading ...
Loading ...
Loading ...
Oven Light
The oven light is a standard 40-watt appliance bulb. Before 2. Turn the glass bulb cover in the back of the oven
replacing, make sure the oven and cooktop are cool and the counterclockwise to remove.
control knobs are in the off position. 3. Turn bulb counterclockwise to remove from socket.
To Replace:
1. Unplug range or disconnect power.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
Cooktop will not operate
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
Operation
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged.
Household fuse is blown, or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is not set
correctly.
On ceramic glass models, the See the control lock keypad feature in the "Feature Guide."
oven control lockout is set.
Excessive heat around Cookware is not the proper size. Use cookware about the same size as the surface cooking
cookware on cooktop area, element or surface burner. Cookware should not extend
more than 1/2'(13 mm) outside the cooking area.
Cooktop cooking results not Control knob set to incorrect heat See "Cooktop Use" section.
what expected level
Cooktop element cycles on
and off on High setting.
Oven will not operate
Range is not level.
Element cycling due to a
temperature limiter
Delay start is set.
Control lock is on.
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
See "Cook Time" section.
Press and hold START for 3 seconds to unlock.
Control is in Demo Mode. Press and hold START TIME for 10 seconds to exit Demo
Mode. Demo Mode is used for display models in a showroom.
Electronic oven control set See "Electronic Oven Controls" section.
incorrectly
Oven temperature too high or Oven temperature needs See "Oven Temperature Control" in the "Electronic Oven
too low adjustment. Controls" section.
Oven indicator lights flash Power to range is turned on or See "Control Display" in the "Electronic Oven Controls"
restored, section. If the indicator lights keep flashing, call for service. See
cover for contact information.
Display shows messages Power failure (display shows Clear the display. On some models, reset the clock, if needed.
flashing time) See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter Depending on your model, press CANCEL to clear the display.
followed by number) See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See cover for contact
information.
Self-Cleaning Cycle will not
operate
Start needs to be pressed so a
cycle can begin (display shows
"PUSH" or "PSH").
The oven door is not closed. Make sure the oven door is fully closed.
The Self-Cleaning function has See the "Self-Cleaning Cycle" section.
not been entered correctly.
A Timed Cooking function has See the "Cook Time" section.
been entered.
The range is in Sabbath Mode. See the "Sabbath Mode" section.
See the "Start" keypad feature inthe "Feature Guide" section.
14
Loading ...
Loading ...