Loading ...
Loading ...
Loading ...
Troubleshooting
First try the solutions suggested here or visit our website at www.whirlpool.com/product_hetp -
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
"LF"
"PF" (power failure)
"L2" Diagnostic Code
(tow or no line voltage
condition)
"F# E#" (F1 El, F3 El,
etc.) variable service
codes
"Loc" or "Lc"
Lint filter removed.
The drying cycle has been interrupted
by a power failure.
There may be a problem with your
home power supply, keeping the
dryer's heater from turning on.
The dryer is in need of service.
The Control Lock is enabled.
Indicates that the HybridCare TM filter has been removed. Place
filter into dryer and make sure the handle is properly seated.
Touch and hold START to restart the dryer.
NOTE: The Control Lock function may be enabled when
recovering from a power failure. To unlock the control,
touch and hold CONTROL LOCK for at least 3 seconds.
The dryer wilt continue to run when this diagnostic code is
present. Touch any pad to clear the code from the display
and return to the estimated time remaining.
NOTE: This error will only show during the initial installation.
Try the following:
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses or breakers.
Replace the fuse or reset the circuit breaker.
Confirm that the power cord is properly installed. Refer to
the Installation Instructions for details.
Select a Timed Dry heated cycle, and restart the dryer.
Ifthe message persists, consult a qualified electrician.
If a code beginning with an "F" appears in the display,
alternating between F# and E#, the dryer control has
detected a problem that requires service. Call for service.
Touch and hold CONTROL LOCK for 3 seconds to unlock
the controls of the dryer. During this time the LED Display
will count down 3-2-1. When the Control Lock is disabled,
the LED Display wilt clear.
16
Loading ...
Loading ...