Loading ...
Loading ...
Loading ...
20
SOLUTIONS TO COMMON PROBLEMS
Dishwasher Won’t Run or Fill (error code i10)
• Check to see if circuit breaker is tripped or if a fuse is
blown.
• Check to see if the water supply is turned on and the
pressure of the water supply is not too low. (Contact
your local water company).
• Check to see if the water tap is open and is not
clogged.
• Check to see if cycle is set correctly. (See Operating
Instructions).
• Check to see if the dishwasher is not set for Delay
Start.
• Check and ensure the door is closed and latched.
• Check to see if the lter in the inlet hose is not clogged
and is free of kinks and bends.
Dishwasher Does Not Drain Properly (error
code i20)
• If unit is hooked up to a food waste disposer, make
sure the disposer is empty.
• Check to see if the knockout plug has been removed
from inside the food waste disposer inlet.
• Check the sink spigot is not clogged.
• Check to see if drain hose is free of kinks and bends.
• Check to see if the cycle is complete, not in a pause.
Dishwasher has an Odor
• Soiled dishes left in dishwasher too long can create an
odor. Use Rinse cycle.
• There will be a “new” smell when rst installed. This is
normal.
• Check to see if unit is draining properly. (See Dish-
washer Does Not Drain Properly).
Stains on Tub Interior
• Washing large amounts of dishware with tomato based
soil can cause a pink/orange appearance. This will not
affect performance and will gradually fade over time.
Pre-rinsing or using the Rinse cycle will reduce the
chance of staining. Using no heat dry option will lessen
staining.
Removing Spots and Film
Hard water can cause lime deposit buildup on the interior
of the dishwasher. Dishes and glasses may also get spots
and lm for a number of reasons. (See Glassware/Flatware
Spotted or Cloudy section). To remove buildup, and lm,
clean using the following instructions:
1. Load clean dishes and glasses in normal manner. Do
not load any metal utensils or silverware.
2. Do not add detergent.
3. Select the NORMAL WASH cycle. Press START pad.
Close and latch the door.
4. Allow dishwasher to run until it starts the second water
ll (approximately 10 minutes).
5. Unlatch an and open door and pour 2 cups of white
vinegar into the bottom of dishwasher.
6. Close and latch door and allow cycle to nish.
Loading ...
Loading ...
Loading ...