Loading ...
Loading ...
Loading ...
Operating your Fan
REMOTE CONTROL
The remote requires a line-of-sight path to allow for the signal to be received by the unit.
Position the unit so the receiver lens is visible from the remote control.
The symbols on the remote correspond to the symbols on the main unit.
The remote control supplied with this heater uses a CR2032 coin type battery.
DANGER IF SWALLOWED
MODE: Pressing the ’ MODE’ button will set the FAN into
NORMAL , NATURAL or SLEEP mode.
• NORMAL Mode: the fan will work at any speed you set up.
• NATURAL Mode: the fan will start work at high speed for 15 seconds, medium speed for 15
seconds and low speed for 15 seconds then cycle back up to high speed and back down
again.
• SLEEP Mode: if you set the mode at high speed, fan will work at high speed at 30 mins, then
transfer to middle speed at 30 mins and transfer to low speed until fan stop working.
TIMER: The fan is equipped with a timer that allows you to set its length of operation from 1
hour to 24 hours in 1 hour increments.
WIFI: Hold down the Power button for 5 seconds and the Wifi icon will begin to flash. The fan is
now in pairing mode. See Wifi instructions further on in this manual for how to download our
app and pair your device.
Loading ...
Loading ...
Loading ...