Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Powercord not plugged in. Plug in power cord.
Stops
No power at plug. Checkelectrical source or call
electrician,
Fuse blown or circuit Replace fuse or reset circuit breaker,
breaker open, Ifproblem continues,call electrician,
Usingan extension cord, Do not use extension cords,
Timer is not lined up. Turn timer to the right slightly
and pull to start,
Timer knob not pulled out. Set and pullout knob,
Washer at pause in Allow cycle to continue (see
PERMANENT PRESS II Cycle "Operation Your Washer"),
(approximatelytwo minutes),
Machine is overloaded. Wash smaller loads,
Agitator Not The top of the agitator moves This is normal,
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higherthan the highestwater
Completely level.This creates a perception
Filling of the washer not being full,
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves, This is normal,
Unit not level, Ensure front feet are installed and
nuts are tightened. Level washer,
Reset rearlegs (see "Installation
Instructions," Section G).
Lint on Load Improper sorting, Sort lint givers from lint takers
and by color,
Overloading, Lintcan be trapped in load if
overloaded, Wash smaller loads,
Paperor tissue in pockets, Clean out pockets before washing.
Notenough detergent, Use enough detergent to
hold lint in water,
Detergent not dissolving, UseAutomatic Temperature Control
Water temperatures lower (ATC).ATC ensures wash water
than 70°F (21°C). temperature will bewarmer than
70°F (21°C).
37
Loading ...
Loading ...
Loading ...