Loading ...
Loading ...
Loading ...
Page 6 of 8 Zip Filter Tap - Installation & Operating Instructions - 801085 - November 2012 v1.00
Performance Data Part Number 91289
Performance Data Sheet
Use Replacement Catridge 91289
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system as specified in NSF/ANSI Standard 42 and NSF/ANSI Standard 53.
System tested and certifed by NSF
International against NSF/ANSI Standard
42 and Standard 53 for the reduction of
substances as listed below according to
Standard 42 and Standard 53.
Substance
Reduction
Average
Infl uent
NSF/ANSI specifi ed
Challenge Concentration
Avg %
Reduction
Average
Product
Water
Concentration
NSF Max
Permissible
Product Water
Concentration
Australian/ New Zealand
(AS/NZS Standard 3497)
Max Permissible Prod-
uct Water Concentration
NSF
Reduction
Require-
ments
NSF Test
Report
Chlorine Taste
and Odor
2.0 mg/L 2.0 mg/L ±10% 97.3% 0.05 mg/L N/A 5.0 mg/L 50% J-00109688
Cyst* 140,000
cysts/L
Minimum 50,000 cysts/L >99.99% 3 cyst/L N/A 1 cyst/100 L 99.95% J-00109693
Lead pH @6.5 0.150
mg/L
0.15 mg/L ± 10% >99.3% 0.001 mg/L 0.010 mg/L 0.01 mg/L N/A J-00109691
Lead pH @8.5 0.150
mg/L
0.15 mg/L ± 10% 99.3% 0.001 mg/L 0.010 mg/L 0.01 mg/L N/A J-00109692
Capacity: 3,785 litres Contaminant Reduction Determined by NSF testing.
Test Conditions: pH7.5, Pressure: 415 kPa, Flow Rate: 1.9L/min
* Based on the use of Cryptosporidium parvum oocysts
Application Guidelines/ Water Supply Parameters
Service Flow 1.9 Ipm
Water Supply Potable Water
Water Pressure 172 - 862 kPa
Water Temperature 4.4ºC - 38ºC
WARNING
To reduce the risk associated with ingestion of contaminants:
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before and after the system.
Systems certifi ed for cyst reduction may be used on disinfected water that may contain fi lterable cysts.
EPA Establishment Number 070595-MEX-001
CAUTION
To reduce the risk associated with property damage due to water leakage:
• Read and follow Use Instructions before installation and use of this system.
• Installation and use MUST comply with all state and local plumbing codes.
• Do not install if water pressure exceeds 862 kPa. If your water pressure exceeds 551.68 kPa, you must install a pressure limiting
valve. Contact a plumbing professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a water hammer
arrester. Contact a plumbing professional if you uncertain how to check for this condition.
• Do not install on hot water supply lines. The maximum operating water temperature of this filter system is 38ºC.
• Protect filter from freezing. Drain filter when temperatures drop below 4.4ºC.
• The disposable filter cartridge must be replaced every 12 months or at the specified service cycle, or sooner, if a noticeale reduction
in flow rate occurs.
It is essential that the manufacture’s recommended installation, maintenance and filter replacement requirements be carried out for the
product to perform as advertised. See installation Manual for details.
Note: While the testing was performed under standard laboratory conditions, actual performance may vary.
Loading ...
Loading ...