Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Remove the rubber mat(s) from the top of the work surface
and set aside.
(2=5cm)
2,
3.
Check the spacing between your washer and dryer. If
necessary, move your washer or dryer so that there is a
space of approximately 1" (2.5 cm) between them.
Check that the washer and dryer are level front to back and
side to side and the difference in height is no more than
%" (0.95 cm). Place a level on both the washer and dryer to
determine any difference in height. If necessary, adjust the
washer or dryer feet.
NOTE: Refer to your model's Use and Care Guide for tools
required and leveling instructions.
4. Place the work surface on top of the washer and dryer.
Holding the front edge up, hook the back edge over the back
of the washer and dryer. Center it left to right so that the
alignment pads fit in the space between the washer and
dryer.
5. Check that the top of the washer and the bottom of the
rubber mat(s) are clean and set in place on top of the work
surface.
6. Dispose of/recycle all packaging materials.
WORK SURFACE CARE
The work surface can be used for sorting, treating and folding
laundry and for storing various laundry products.
IMPORTANT: The work surface is not intended for ironing. Using
an iron on the work surface could cause it to become discolored.
Cleaning the Work surface
• Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the work surface to keep it looking new.
• Use mild soap and water; do not use abrasive products.
Loading ...
Loading ...
Loading ...