Loading ...
Loading ...
Loading ...
14
15
GB
WARNING
If the information in this manual
is not followed exactly, a fire or
explosion may result causing
property damage, personal injury or
death.
Introduction
Please read these instruction
COMPLETELY AND CAREFULLY. They
will save you time and effort and help to
ensure optimum oven performance.
Be sure to observe all WARNINGS.
These installations are intended for use
by a qualified installer.
In addition to these instructions, the
oven shall be installed:
• In the United States, in accordance
with the National Electric Code/
State and Municipal codes and/or
local codes.
• In Canada, in accordance with
Canadian Electric Code C22.1-
latest edition/Provincial and
Municipal codes and/or local
codes.
These shall be carefully followed at all
times.
NOTE: IF INSTALLING YOUR OVEN
IN CANADA PLEASE CHECK TO
MAKE SURE THAT YOU HAVE
A MODEL WITH THE CANADIAN
LISTING.
MARK, AS SHOWN ABOVE:
Mark as shown above means the oven
complies with both US and CANADIAN
Standards.
Tools you will need
The following tools are needed to install
your new oven:
• Tape measure and straight edge
or rules
• Pencil
• Phillips screwdriver
• Level
• Wire cutters and wire stripper
• Hand or saber saw
• 1” (2,5 cm) Hole saw
• Drill and drill bit
• Safety gloves and goggles
• Volt meter (0-250VAC)
Packaging
Remove all tape and packaging before
using the oven.
Destroy the packaging after unpacking
the oven following the rules in force in
your town. Never allow children to play
with packaging material.
Power requirements
The oven must be supplied with the
proper voltage and frequency. The oven
is manufactured to be connected to a
three-wire, single phase,120/240V, 60
Installation instructions
Location of rating plate
14
15
GB
Hz AC electrical supply on a separate
circuit fused in both sides of the line. A
circuit breaker or time delay fuse sized
not to exceed the circuit rating of the
appliance specified on the rating plate
located on the frame behind the door
of the oven is recommended.
The oven must be supplied with copper
or aluminum wires.
If aluminum wire is provided to
connect oven to branch circuit, UL
listed connectors for joining copper
and aluminum must be used. Follow
instructions provided with connectors.
If is recommended that you have the
electrical wiring and hook-up of your
oven performed by a qulified electrician.
After installation is complete have the
electrician show you where the main
disconnect is and which of the circuit
breakers/fuses are for the oven.
Choosing oven location
Carefully select the location where the
oven will be placed.
The oven should be located for
convenient use in the kitchen, but away
from strong drafts.
Strong drafts may be caused by open
doors or windows, or by heating and/
or air conditioning vents or fans. Make
sure that electrical power can be
provided to the location selected.
Steps for installation
The following pages provided the
necessary information for proper
installation of the oven and are
arranged as follows:
• Technical Data
• Installation Cutout Dimensions,
Required Clearances and
Mounting instructions for:
- Under counter installation, Single
Oven
- Wall installation, Single Oven
• Electrical supply and Wiring
Requirments, Programming
required if connecting to 120/208
Volt Circuit. Electrical Connections
for 3-wire or 4-wire Branch Circuit.
• Final Checklist.
Loading ...
Loading ...
Loading ...