Loading ...
Loading ...
Loading ...
3. Put the wet items on top of the drying rack. I.eave space between the items so air can
reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying rack.
I
7. You must select a time by pressing TIME ADJUST + (plus) or- (minus). Reset time as
needed to complete drying. Refer to the following table.
8. Press START/PAUSE.
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting, and drying time. Actual drying time will depend on the amount of
moisture items hold.
Rack Dry Setting Temp. Time*
(minutes)
4. Close the doon
5. Press the POWER/CANCEl. button.
6. Select a Timed Dry cycle and temperature (see following chart). Items containing foam,
rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
Wool Sweaters Timed Dry I.ow 60
Block to shape and lay flat on the drying rack.
Stuffed toys or pillows Timed Dry I.ow 60
Cotton o r po [yester fiber fi lied
Stuffed toys or pillows Timed Dry Air Fluff 90
Foam rubber filled (no heat)
Sneakers or canvas shoes Timed Dry Air Fluff 90
(no heat)
*Reset time to complete drying, if needed.
DRYER CARE
......... <:_1
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
<9 .........
Clean the lintscreen before each load.The controlpanel has an indicatorlightto remind you
to clean the lintscreen before each load. A screen blocked by lintcan increase drying time.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
• If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every load cleaning
1.
The lint screen is located in the door opening of the dryer. Pull the lint screen straight up.
Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into place.
Loading ...
Loading ...
Loading ...