ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0249
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
200820
Hardware Package (included):
Mounting Strap Unit (A) Mounting Screw (B) Wire Connector (C) Bolt Nut (D)
Outlet Box
House Ground Wire
Wire Connector (C)
Mounting Strap Unit (A)
Fixture Mounting Screw
Green Ground Screw
Mounting Screw (B)
1. Attach the mounting strap unit (A) to the outlet box
using two mounting screws (B).
2. Screw 185mm long rods and 160mm short rods to
the threaded pipes of fixture according to the
figure.
3. Pull out the source wires from the outlet box.
Make wire connections using wire connector (C)
as follows:
---Connect the black wire from the fixture to the
black wire from the power source.
---Connect the white wire from the fixture to the
white wire from the power source.
---Attach the fixture ground wire to the mounting
strap unit (A) with the green ground screw,
then connect it to the house ground wire with
a wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the fixture canopy to the mounting strap
unit (A) by inserting the fixture mounting screw,
then secure it with two bolt nuts (D).
5. Install bulbs (not included).
Check relamping label at socket area or
packaging for maximum wattage allowed.
Turn off the power at fuse or circuit box
Installation Steps
Fixture Canopy
Fixture
Bolt Nut (D)
Long Rod
Threaded Pipe
Socket
Short Rod
Type ST Max.40W
Vintage Bulb
(not included)
Long Rod
Short Rod
Short Rod
Long Rod
Turn on the power at fuse or circuit box
Loading ...
