Loading ...
Loading ...
Loading ...
Page 4
Parts Supplied
1 - Hardware bag
• 2 - 4.5x13 mm installation screws
• 8 - Charcoal lter clips
4 - Charcoal Filters
1 - Plastic grid
Installation Instructions
Range Hood Model Recirculating Kit
HMDW30WS RECHMDW30
HMDW36WS RECHMDW36
If it is not possible to vent cooking fumes and vapors to
the outside, the hood can be used in the non-vented
(recirculating) version, using the recirculating kit .
Fumes and vapors are recycled through the round grid.
Installation through the soft / cabinet
Depending on your recirculating installation, take into con-
sideration the next diagram:
E
A
B
G
D
F
H
I
A
B
G
F
C
D
E
J
A. Ceiling
B. Recirculating grid
Soffit
C.
D. 6” (15.2 cm) vent
E. Range hood
F. Cabinet
G. Wall
H. 12” (30.5 cm) min. cabinet
height
I. 17” (43.2 cm) min. vent cover
height
J. Top of the cabinetry
1. Measure and mark the centerline of the cabinet to the
soft above.
2. Measure from the bottom of the cabinet to the
centerline of where the vent will come through the
soft. Mark the location and use a saber saw or keyhole
saw to cut a 5¾” (14.6 cm) hole for the recirculating
grid.
3. Install the recirculating grid with the 2 provided screws.
A
B
A. Recirculating grid
B. Centerline
Charcoal Filter Replacement
1. Remove the grease lters of the hood.
2. Evenly position the charcoal lter to the backside of the
grease lter.
3. Place 2 spring clips into the place (see image) to secure
the charcoal lter to the metal lter.
NOTE: The charcoal lters cannot be cleaned. Filters should
be replaced every 4-6 months (depending on hood usage).
Loading ...
Loading ...
Loading ...