Loading ...
Loading ...
Loading ...
HOW TO USE 23
HOW TO USE
Before use
Clean the refrigerator.
Cleanyour refrigerator thoroughly and wipe off all dust that accumulated during shipping.
_z_CAUTION
• Do notscratchtherefrigeratorwitha sharp objectoruse a detergentthatcontainsalcohol,a flam-
mable liquidor an abrasivewhen removingany tape oradhesivefrom the refrigerator,.
• Do not peeloffthe model or serialnumber labelorthe technicalinformationon the rearsurfaceofthe
,, refrigerator.
- _ NOTE
Remove adhesive residue by wiping it off with your thumb or dish detergent.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn off the icemaker if the refrigerator is not yet connected to the wafer supply.
Turn off the automatic icemaker and then plug the power plug of the refrigerator into the grounded electric
outlet.
* This is applicable only to certain models.
_z_CAUTION
Running the automaticicemakerbeforeconnectingitto thewater supplymay cause the refrigeratorto
malfunction.
\
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in it. Check the flow of cold
air in the freezer compartment to ensure proper cooling.
_-z_ CAUTION
Putting food in the refrigerator before it has cooled could cause the food to spoil, or a bad odor could
, remain inside the refrigerator.
The refrigerator makes a loud noise after initial operation.
This is normal. The loudness will decrease as the temperature lowers.
Open refrigerator doors and freezer drawers to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive tape from inside the refrig-
erator and open the refrigerator doors and the freezer drawers for ventilation.
Loading ...
Loading ...
Loading ...