Loading ...
Loading ...
Loading ...
Removing the left (freezer) door with water line
connection.
• Pull up the water feed tube while pressing area
(Figure 1) as shown in the figure below.
• NOTE: If a tube end is deformed or abraded, trim the
part away. Disconnecting the tube under the door
causes about 0.13 gallons (0.5 liters) water to flow out.
Put a large container at end of tube to prevent water from
draining onto the floor.
Figure 1
(a
(1)\
1. Open the door. Remove the top hinge cover screw (1).
2. Use a flat blade screwdriver to pry back the hooks
(not shown) on the cabinet underside of the cover (2).
Lift up the cover.
3. Disconnect all the wire harnesses (3).
4. Remove the grounding screw (4).
5. Rotate hinge lever (5) counterclockwise. Lift the top
hinge (6) free of the hinge lever latch (7).
NOTE: Regardless of the type of hinge lever, removal
process is the same.
[] CAUTION: When lifting the hinge free of the latch,
be careful that the door does not fall forward.
6. Lift the door from the lower hinge pin being careful to
pull the water lines through the lower hinge pin.
7. Place the door, inside facing up, on a nonscratching
surface.
Reinstalling the right (Refrigerator) door
..-(2)
Type 1
1. Place the door onto the lower hinge pin.
2. Fit top hinge (4) over hinge lever latch (5) into
place. Rotate lever (3) counterclockwise to secure
hinge.
NOTE: Regardless of the type of hinge lever, removal
process is the same.
3.Hook tab on switch side of corner under edge of wire
opening in cabinet top. Position cover (2) into place.
Insert and tighten cover screw (1).
10
Loading ...
Loading ...
Loading ...