Loading ...
Loading ...
Loading ...
Some units are equipped with a Traceable
Thermometer/ Alarm that simultaneously displays
minimum, maximum and current interior temperatures
and provides a visual and audible signal when the
temperature inside the unit falls outside the set
temperature range.
The temperature sensor, or probe, is enclosed in a
glycol-filled bottle that you insert into the location to be monitored, such as
inside a refrigerator or freezer, once the unit has been programmed. The
thermometer/alarm itself can be attached to the door of the unit with the
magnet on the back, or it can be placed on a convenient table or shelf.
Power to the Traceable Thermometer/Alarm is supplied with a lithium iron
disulfide battery with a 10-year shelf life. When it is inserted correctly, the
unit will beep and all segments of the LCD display will be temporarily
activated. (Note that alarm temperatures will have to be reset after replacing
the battery.)
The temperature display can be switched between Celsius (°C) and
Fahrenheit (°F) by sliding the °C/°F button located on the back of the unit.
If you find that it is necessary to change the temperature setting for your
digital-thermostat controlled appliance,
please refer to the following instructions.
The front panel of the thermostat is
illustrated here:
To see the SET POINT:
Push and immediately release the set key. The LED will flash and show the
set point value. Wait 15 seconds and the inside temperature will display
again. Typically, refrigerator models are set at 4°C and freezers at -18°C.
To change the SET POINT:
Push set and within 15 seconds, press ▲ or ▼ until the desired set point is
shown. The new setting will be memorized after 15 seconds provided no other
keys are pushed, or you can press the set key immediately.
Notes: 1. The minimum and maximum limits of the temperature range of your
thermostat are preset and locked by us. For refrigerator models, that
range is 33°F to 40°F. For most freezers, the range is -25°C to -1°C. To
reset these ranges, either call us or find information on our website
under Troubleshooting.
2. If the appliance is unplugged, has lost power or is turned off, you must
wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the appliance will not start.
DIGITAL THERMOSTAT INSTRUCTIONS
TRACEABLE THERMOMETER / ALARM
Felix Storch, Inc.
Page 10
°C
°F
set
▼
▲
Loading ...
Loading ...
Loading ...