Loading ...
Loading ...
Loading ...
8
Parts Supplied (all models):
Leveling legs (4) (Length and appearance of legs may vary
according to model)
Parts package is located in dryer drum. Check that all parts are
included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or stack kit.
Parts Needed (steam models):
“Y” connector
Rubber washer
2' (0.6 m) inlet hose
5' (1.52 m) inlet hose
Vented Models:
Vent Clamps, elbows, and vent work
Parts Needed (not supplied with dryer):
Additional parts may be required, depending on your installation.
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements” before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the Quick Start
Guide for service contact information.
Available Accessories:
Accessories and replacement parts are available for your model.
For ordering and contact information, please reference your Quick
Start Guide.
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline,
away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Place dryer at least 18 inches (460 mm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
� For vented models: A location allowing for proper exhaust
installation. See “Venting Requirements.”
� A separate 30 A circuit for electric dryers.
� If you are using power supply cord, a grounded electrical outlet
located within 2 ft (610 mm) of either side of dryer. See
“Electrical Requirements.”
� A sturdy floor to support dryer weight of 200 lbs (90.7 kg).
Also, consider the combined weight of the companion
appliance.
� For steam dryers: Cold water faucets located within 4 ft
(1.2 m) of the water fill valves, and water pressure of 20–
120 psi (138–827 kPa). You may use the water supply for your
washer using the necessary parts as noted (which you may
need to purchase).
� Level floor with a maximum slope of 1" (25 mm) under the
entire dryer. If the slope is greater than 1" (25 mm), install
Extended Dryer Feet Kit. If not level, clothes may not tumble
properly and automatic sensor cycles may not operate
correctly.
� For garage installation, place dryer at least 18" (460 mm)
above the floor. If using a pedestal, you will need 18" (460 mm)
to bottom of the dryer.
� The dryer must not be installed or stored in an area where it
will be exposed to water and/or weather.
IMPORTANT: Do not operate dryer at temperatures below 45°F
(7°C). Lower temperatures may cause dryer not to shut off at end
of automatic sensor cycles, resulting in longer drying times.
Installation clearances:
For each arrangement, consider allowing more space for ease of
installation and servicing, spacing for companion appliances, and
clearances for walls, doors, and floor moldings. Space must be
large enough to allow the dryer door to fully open. Add spacing on
all sides of the dryer to reduce noise transfer. If a closet door is
used, top and bottom air openings are required. Louvered doors
with equivalent ventilation openings can be used.
Loading ...
Loading ...
Loading ...