11.1 TROUBLESHOOTING GUIDE
Warning!
For your own safety, turn the switch off and remove the plug from the power supply socket.
Problem Possible Cause Remedy
Breaking blades. Wrong tension.
Over working blade.
Wrong blade application.
Twisting blade.
Adjust blade tension.
Reduce feed rate.
Use narrow blades for cutting
thin material or sharp curves,
wide blades for thicker
material or straight cuts.
Avoid side pressure on blade
Motor will not run. Defective cable or plug.
Defective motor.
Replace defective parts.
Consult your service agent.
Any attempt to repair this
motor may be dangerous
unless the repair is carried
out by a qualified service
agent.
Vibration.
Note: There will always be
some vibration when the saw
is running due to the motor
operation.
Incorrect mounting of saw.
Unsuitable mounting surface.
Loose table.
Loose motor mounting.
Refer to the mounting
instructions in this manual.
The heavier your work
bench is, the less vibration.
A plywood workbench is not
as good as solid timber.
Tighten table locking knob.
Adjust table if necessary.
Tighten mounting screws.
Blade runout. Blade guides not aligned. Check blade guide settings
as per manual.
Note: Repairs should only be carried out by a qualified person.
13.1 EXPLANATION OF SYMBOLS
WEEE – Waste Electrical &
Electronic Equipment.
Do not dispose of Waste Electrical & Electronic
Equipment in with domestic rubbish.
Read the instruction manual.
Wear face mask and safety
glasses.
Keep hands away from blade.
Disable the machine before
attempting to maintain it.
