Loading ...
Loading ...
Loading ...
No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”. (v p. 155)
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the sound mode, no sound may be output from the
subwoofer. (v p. 154)
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 159)
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. (v p. 159)
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 38)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
Dolby PL
g mode or DTS Neo:6 mode cannot be selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”. (v p. 155)
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup. (v p. 144)
0
Switch to a sound mode other than “Direct”. (v p. 93)
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 124)
0
Switch to a sound mode other than “Direct”. (v p. 93)
Contents Connections Playback Settings Tips Appendix
186
Front panel Display Rear panel Remote Index
Loading ...
Loading ...
Loading ...