GE - General Electric PTS18SBSWRSS GE refrigerator - s series

User Manual - Page 20

For PTS18SBSWRSS.

PDF File Manual, 104 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] REMOVE FREEZER DOOR
Tape the door shut with masking tape.
Remove the hinge coxer on top of the fl'eezer door
(on some models).
Remo_e the two Tmx a'screws, then litt the hinoe
straight up to fl'ee the hinge, Ifin ti'om the socket in
the top of the dora:
TopHinge----_-__
Remove the tape and tilt the door away from the
cabinet. I,ifl it off the center hinge pin.
Set the door on a non-scratching surface with
the inside up.
[] REMOVE REFRIGERATOR DOOR
%q)e the door shut with masking rope.
Remoxe the center hinoe_ pin with a ,/8 socket
and ratchet.
i
PlasticWasher
HingePin--
CenterHinge _
Bracket
I
FreshFoodDoor
Remove the tape and tilt the door away fl'om the
cabinet. Remove and save the washer on the hinge pin.
I,ifl the door straight up to ti'ee its bottom socket fl'om
the pin in the bottom hinge bracket.
Set the door on a non-scratching surfilce with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
[] TRANSFER TOP HINGE TO
THE LEFT
Interchange hinge and screws at top right with scre_vs
at the top left of cabinet.
Do not tighten screws on hinge side at this finae.
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_ e it by ,graslring, it
about 6" fl'om each end and pulling its bottom edge
toward VOtl.
Using a Torx _'_drive_; move the bottom hinge bracket
and plastic washer fl'om the fight side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the dora:
0_.] PlasticWasher
Hing,
For models with a base grille, before rei)lacim,_ the
base grille, remo_.e the grille cap by remo'.im,_ the
screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of the
metal clips into the oval vents, making sm'e one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
fin'ward tmtil it snaps into place.
20_
Loading ...
Loading ...
Loading ...