Loading ...
Loading ...
Loading ...
• If the device does not respond at all or not to all of the
key commands, follow the instructions under ‘Setting
the remote control’ or for online setup got to:
www.philips.com/urc.
Setting the remote control
This is only necessary if your TV does not respond to the
SRP 1001. If that is the case, the SRP 1001 does not recognize the
brand and/or model of your TV and you need to program the
remote control to do so. The example below instructs you how to
do this. You can set the remote control either manually or
automatically.
Manually setting the remote control
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual.
One or more 3-figure key codes are
shown for each brand.
Note the first code.
3 Keep keys 1 and 3 on the SRP 1001
pressed simultaneously for five
seconds until the indicator light
remains lit.
4 Then enter the code noted in step
2 using the code keys.
– The indicator light will now flash
twice. If the indicator light flashes
once for an extended period, the
code has not been entered properly
or the wrong code has been entered. Start again from step 2.
5 Point the SRP 1001 at the TV and check that it responds as it
should.
– If the TV responds to all of the key commands, the SRP 1001
is ready for use.
Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next
code from the list.
4 EN
5 sec.
2 x
SRP1001_10_Transfer:125254c4_SRU5110_86 19-06-09 15:15 Pagina 4
Loading ...
Loading ...
Loading ...