Loading ...
Loading ...
Loading ...
assembly
MOUNTING SCROLL SAW TO
MOUNTING BOARD
An alternate method of mounting is to fasten Scroll
Saw to a mounting board The board should be of
sufficient size to avoid tipping of saw while in use.
Any good grade of plywood or chipboard with a 3/4"
minimum thickness is recommended._
1 Follow instructions for mounting to a workbench,
substituting a board 12"x 24" minimum size and
using 1/4 inch fiat head screws, Iockwashers, and
.e
J
24 _ ....
__ COUNTER SINK
FROM BOTTOM
OF MOUNTING
BOARD
p.
16" DIA, HOLES{4)
"_----_ 12-1/2 =[
hex nuts, Screws must be of sufficient length to
accomodate saw base, rubber feet, washers, hex
nuts, and thickness of supporting board
NOTE: Holes must be counter sunk so screw
heads are flush with bottom surface of supporting
board
Locate, mark, and drill holes through mounting
board, and install screws, iockwashers, and nuts
Tighten with wrench
ii ii llll ii lllll ii ii, ,ll,i i
3. Securely clamp board to workbench using C
clampsr
NOTE: Supporting surface where Scroll Saw is
mounted should be examined carefully after
mounting to insure that no movement
during use can result, if any tipping or
walking is noted, secure workbench, legs, or
supporting surface before operating Scroll
Saw.
GUARD
LOCK KNOBS
ADJUSTING GUARD
The Scroll Saw is shipped with a guard arid lock
knobs installed
1 Adjust guard by loosening the two (2) guard lock
knobs and raising guard to desired height above
table Tighten guard lock knobs by hand.
2 Guard should be against top of workpiece to
provide additional control, but permit movement
of workpiece, flat on table.
GUARD
WORKPIECE
L
INSTALLING MITER LOCK KNOB
1 Locate one (1) miter gauge lock knob, one (1)
13/64 x 5/8 x 1/32 washer, and one (1) wedge
among loose parts
2. Insert wedge into tapered recess next to front
miter slot
3 Install washer and knob from underside of table,
by engaging knob into wedge.. Tighten knob by
hand
NOTE: A miter gauge is included with the Scroll
Saw With the wedge locking feature, the
operator can use the miter guage to perform
ripping as well as miter and crosscuts.
MITER GAUGE
WEDGE
1
{
t
WASHER
MITER GAUGE,__
LOCK KNOB _J_
MITER GAUGE
Loading ...
Loading ...
Loading ...