Loading ...
Loading ...
Loading ...
1
GUI Menu Map Setup Information Troubleshooting
[SAT TU]
[ AMP]
The strength of both the SIRIUS satellite and terrestrial signals can
be checked at GUI menu “Source Select” – “SIRIUS” – “Antenna
Aiming” (vpage 6).
Checking the SIRIUS Signal Strength
and Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU] to
select “SIRIUS”.
b When operating via the remote control unit, you cannot select
SIRIUS even by pressing [SOURCE SELECT] to which SIRIUS has
been assigned.
2
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
4
Press <STATUS> until the channel (example: “SR001”)
is displayed.
5
Press [ ] and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
S R 0 0 0 S i r i u s I D
* * * * * * * * * * * *
b Write your own SIRIUS ID for storage use.
Sirius ID :
Sirius ID
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMO].
1
Make the necessary preparations.
q Assign the SIRIUS input.
q
Assign the SIRIUS input.
: “Source Select” – “(input source)” – “Assign” –
“SIRIUS” (vpage 7)
w Change the TUNER(DEV2) setting on the main remote control
unit to SIRIUS.
unit to SIRIUS.
: “Manual Setup” – “Option Setup” –
“Remote (SIRIUS/XM)” (vpage 5)
2
Either turn <SOURCE SELECT> or press [SAT TU] to
select “SIRIUS”.
b When operating via the remote control unit, you cannot select
SIRIUS even by pressing [SOURCE SELECT] to which SIRIUS has
been assigned.
3
When using the main remote control unit to operate,
press [TU] to select mode.
4
Use [ ] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
• The channel switches continuously when [ ] is pressed
and held.
• The song title, artist name, composer name, category and reception
level can be checked by pressing <STATUS>.
• The time (default : 30 sec) for which the on-screen display are
displayed can be set at GUI menu “Manual Setup” – “Option Setup” –
“GUI” – “Tuner”.
• The sub remote control unit can also be used for SIRIUS (vpage
13).
Basic Operation
There is no SIRIUS-dedicated input terminal for AVP-A1HDCI /
AVR-5308CI.
When using an audio input source not used by AVP-A1HDCI /
AVR-5308CI, assign SIRIUS to the source.
<STATUS>
uio p
<SOURCE SELECT>
<TUNING PRESET>
[ TU]
[MEMO]
uiop
[NUMBER
(0 ~ 9)]
[CHANNEL + –]
[SEARCH]
[ENTER]
[A ~ G]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
(AMP mode)
[ ]
(
mode)
<Illustration : AVR-5308CI>
Playback
Loading ...
Loading ...
Loading ...