Loading ...
Loading ...
Loading ...
ge.com
SPEED CYCLE
(on some models
CHINA CRYSTAL
GLASSES
(on some models
RINSEONLY
7.5gal.,35 min.
Thiscycle isfor everyday dishesand glassware.
7.5gal.,35 min.
Thiscgcle isfor lightly soiledchina and crgstal.
7.5gal.,35 min.
Thiscgcle isspecifically designedfor glasses.
2.5gal., 10 min.
For rinsingpartial loadsthat will be washed later Donot usedetergent with this cgcle.
NOTE; The CHINA CRYSTAL/PLASTICS (some models) selector is a toggle pad, toggle the pod until the
desired cycle is indicated.
NOTE; This dishwasher is equipped with a CleanSensor TMwith automatic temperature control, therefore, cycle
length and time may vary depending on soil and temperature conditions.
NOTE; Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for soil
removal and sanitization efficacy.
_]l Enhancements/Extras
The light above the selected pad will be ON to indicate which ENHANCEMENT/ERTRA has been selected.
PRE WASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
(on some models) selected PRIOR to starting the cgcle. This option adds 16 minutes to the cycle time.
NOTE: Cannot be selected with RINSE ONLY cgcle.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energg is saved. For
Light OFF faster air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY Turns the heater on for fast drying. This will extend the time to your wash cgcle bg 8
Light ON minutes for the SPEED CYCLE and 30 minutes for all other cgcles. NOTE: Cannot be
selected with RINSE ONLY cgcle.
LOCK
You can lock the controls to prevent any selections from being mode. Or you con lock
the controls offer you hove started o cycle.
Children cannot occidentally start dishwasher by touching pods with this option
selected.
To unlock the dishwasher controls, touch and hold the HEATED DRY pad for 3 seconds.
The light above the LOCK pad will turn off. To lock the dishwasher, touch and hold the
HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on.
ADDED HEAT or When selected, the cgcle will run longer with heating elements on to improve both
EXTRAHOTWASH wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cgcle.
(on some models)
DELAY HOURS
You can delag the start of a wash cgcle for up to 9 hours. Touch the DELAY HOURSpad
to choose the number of hours you want to delag the start of the cgcle; then touch
START/RESET.The machine will count down and start automatically at the correct time.
Touching START/RESETa second time will cancel the DELAYSTART selection. NOTE: If
you forget to fully close the door, a reminder signal will beep until you do so.
RESET
To change a cgcle after washing starts, touch the START/RESETpad to cancel the
cycle. The START/RESETlight will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher
can be reprogrammed and restarted.
Loading ...
Loading ...
Loading ...